Once you've completed the activation process, please follow the steps below to ensure your tracker begins reading properly:
GL300 Tracker
- Charge your tracker. Ensure your tracking device is fully charged. The device typically takes 4-6 hours to charge. The red PWR LED will flash while the battery is charging, then will stay solid once fully charged. For an overview of the charger, please refer to our GL300 User Manual ↗️
- Reboot your tracker. To power down, hold down the small power button on the top of the unit for 10-15 seconds, then release. Repeat this step to turn the unit back on. (Please Note: the unit cannot be plugged into the charger while performing this step). Learn more about how to Reboot your GL300.
- Test your tracker. Walk or drive around outside for 5 to 10 minutes with your tracker. The lights will indicate the connection of the tracker. Click here to learn more about the lights on your tracker.
- Check your signal. Log in to your account to see if you're getting a signal.
Please note: After you have activated your tracker, click here to review the next steps for using your tracker on the platform.
OBD Tracker
1. Plug your tracker into your vehicle's OBD port. Click here to learn more about installing the OBD tracker.
2. Test your tracker. Take your tracker for a short 10-15 minute drive to connect to the platform. The lights will indicate the tracker's connection:
• The blue light (GPS) will go from blinking to a solid blue.
• The green light (CELL) will go from blinking rapidly to a slower blink.
• Click here to learn more about the lights on your tracker.
3. Check your signal. Log in to your account to see if you're getting a signal.
Please note: After you have activated your tracker, click here to review the next steps for using your tracker on the platform.
Hardwired Tracker
1. Install Tracker. We recommend installation by a professional technician. The tracker will be plugged into the vehicle's power supply and will be typically be placed under the dashboard of your car.
2. Test your tracker. Drive around outside for 10 to 15 minutes with your tracker. The lights will indicate the tracker's connection.
• The red light (GPS) will go from blinking to a solid red.
• The green light (CELL) will go from blinking rapidly to a slower blink.
• Click here to learn more about the lights on your tracker.
3. Check your signal. Log in to your account to see if you're getting a signal.
Please note: After you have activated your tracker, click here to review the next steps for using your tracker on the platform.